OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05F3

Rear Drive Shaft Speed Sensor Circuit

Catch-all electrical fault for the rear drive shaft speed sensor circuit, stored when the controller detects a problem but does not narrow it to low, high or intermittent. Typical are an open supply or signal wire, a failed sensor IC or a fault in the module input. Two-wire Hall sensors such as the Allegro A19420 report speed as alternating current levels and can also signal an internal error; a current outside both bands cannot be read as speed. The value matters for disconnecting AWD systems: BorgWarner reads sleeve speed and position with one Hall sensor and engages a dog clutch only within about 100 to 200 rpm, and Audi names sensor G970 in its quattro ultra diagnosis. No maker documents C05F3 itself; C05F0 and C05F1 are the more specific variants.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / F3

Possible causes

  • Open signal or supply wire between sensor and module high
  • Failed speed sensor IC medium
  • Connector not latched or pins pushed back medium
  • Faulty input stage in the AWD control module low

Symptoms

  • AWD or 4WD service message, all-wheel drive switched off
  • Vehicle drives on the primary axle only
  • No drive shaft speed shown in live data

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for C05F3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication