OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05F2

Rear Drive Shaft Speed Sensor Circuit Intermittent

The speed signal from the rear drive shaft drops out or jumps for short moments and then recovers, so the AWD controller sees pulse gaps or sudden speed steps that no real shaft could make. Such sensors are often two-wire Hall ICs whose supply current toggles between two levels; Allegro specifies about 7 and 14 mA for its A19420 and stresses stable output despite sudden air gap changes, so short dropouts usually point to wiring, connector or mounting rather than the IC. American Axle uses a speed sensor on the rear drive module pinion shaft to judge synchronisation before a disconnect clutch engages; Audi lists the drive shaft speed sensor G970 for quattro ultra. No maker documents C05F2 itself; permanent faults are C05F0, C05F1 or C05F3.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / F2

Possible causes

  • Loose, corroded or water-affected connector at the sensor high
  • Harness chafed or broken where it flexes near the axle or drive shaft medium
  • Sensor not seated firmly, air gap varies with vibration medium
  • Damaged or dirty target ring on the shaft low

Symptoms

  • AWD or 4WD warning appears now and then and disappears again
  • All-wheel drive briefly unavailable, often on rough roads
  • Code stored as history without a current fault

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for C05F2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication