C05F1
Rear Drive Shaft Speed Sensor Circuit High
Here the rear drive shaft speed signal reads above its valid range, as caused by a short to supply voltage, a damaged sensor IC or a fault at the module input. With a two-wire Hall sensor the module watches the current between a low and a high level (Allegro A19420: about 7 and 14 mA); a current clearly above the upper band cannot be a speed pulse. Without a plausible prop shaft speed, a disconnecting AWD system cannot judge when the rear driveline has caught up with the wheels, which the American Axle and BorgWarner patents require before engagement. Audi's quattro ultra uses such a sensor as G970. No manufacturer publishes C05F1; C05F0 is the low case, C05F4 the plausibility check.
Possible causes
- Sensor signal line shorted to supply voltage high
- Damaged sensor IC drawing excessive current medium
- Faulty sensor input in the AWD module low
Symptoms
- AWD warning, all-wheel drive not connected
- Fault sets immediately at ignition on
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for C05F1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.