C05F0
Rear Drive Shaft Speed Sensor Circuit Low
The signal of the rear drive shaft speed sensor stays below its valid range, typically due to an open circuit, a short to ground or a missing sensor supply. The AWD module needs this speed to match a disconnected rear driveline to the wheels before a clutch closes; American Axle's patent feeds a pinion shaft speed sensor into exactly that synchronisation check. Audi lists the driveshaft speed sensor G970 among the parts tested in quattro ultra fault finding for C05ED00. Many such sensors are two-wire Hall ICs that toggle between two supply currents; Allegro's A19420 uses about 7 and 14 mA, so a current below the lower band, or none at all, cannot be a valid pulse. No manufacturer publishes C05F0 itself; C05F1 is the high counterpart.
Possible causes
- Open sensor wire or loose connector high
- Signal or supply line shorted to ground medium
- Failed Hall sensor IC medium
Symptoms
- AWD warning, all-wheel drive not connected
- Vehicle drives in front-wheel drive only
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for C05F0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.