OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05EF

4WD/AWD Clutch B Position Control Error

The position loop that moves clutch B to a target cannot reach or hold it: commanded and measured actuator position stay apart for too long. Such loops depend on a learned reference. Dana's patent finds the kiss point from motor current plotted against Hall or encoder shaft position; Bosch derives it from two regression lines while the motor pushes against the rising clutch load; in Magna's design the ECU sets how far the ball-ramp ring is rotated. For a dog clutch, BorgWarner reads the axial sleeve position with a Hall sensor. Typical reasons are binding mechanics, a weak motor or low supply voltage, and a reference that no longer matches worn plates. Unlike C05EE, the sequence itself is not the issue. No manufacturer publishes C05EF; C05E6 is the clutch A counterpart.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / EF

Possible causes

  • Binding ball ramp, gear or shift mechanism high
  • Weak actuator motor or low supply voltage medium
  • Learned reference no longer valid after wear or part replacement medium
  • Implausible actuator position signal low

Symptoms

  • AWD malfunction message, AWD disabled
  • Delayed or uneven torque transfer before the fault sets

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C05EF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication