OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05EE

4WD/AWD Clutch B Engagement Fault

The connection sequence of clutch B did not complete: the actuator moved, but speed matching, position feedback or the time window failed. This concerns above all positive dog clutches, which may only close once both halves turn at almost the same speed. BorgWarner's dog-clutch patent starts engagement within roughly 100–200 rpm speed difference and allows full torque only after a Hall sensor confirms about two thirds engagement; Ford's synchronisation patent first spins up the stationary driveline with the rear clutch and then closes a synchroniser in the PTU. Audi states that quattro ultra completes the whole reconnection in around 200 ms. C05EC means the clutch stays open or slips, C05EF a position control deviation. No manufacturer publishes a C05EE case.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / EE

Possible causes

  • Speed of the disconnected driveline not matched in time medium
  • Slow actuator, often from low voltage or cold, thick fluid medium
  • Faulty position or shaft speed feedback medium
  • Worn or chipped dog teeth blocking engagement low

Symptoms

  • AWD unavailable message, sometimes only for one trip
  • Clunk or rattle from the rear when AWD tries to connect

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C05EE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication