OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05EC

4WD/AWD Clutch B Performance/Stuck Disengaged

Clutch B was commanded to connect, but speed signals or actuator feedback show that it carries no torque or has stayed open. In disconnecting systems the second clutch is often a positive shift element rather than a friction pack: Audi's quattro ultra releases both a gearbox-side multi-plate clutch and a decoupler in the rear differential, which autozine describes as an electromechanically operated dog clutch on the right half shaft. For this unit Audi's guided fault finding can end in replacing actuator 2 (V623) or the driveshaft speed sensor G970, as its bulletins note. BorgWarner's dog-clutch patent uses a single Hall sensor to confirm sleeve speed and position before full torque is allowed. No manufacturer publishes a C05EC case; C05ED is the reverse, a clutch that will not open.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / EC

Possible causes

  • Clutch B actuator sticking or too weak to shift the sleeve high
  • Worn shift fork or damaged dog teeth in the rear differential medium
  • Worn friction plates on twin-clutch units medium
  • Low or wrong fluid in the rear drive unit low

Symptoms

  • AWD malfunction message, vehicle drives on the front axle only
  • Wheel spin and traction control interventions on slippery roads

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C05EC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication