OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05EB

4WD/AWD Clutch B Temperature Too High

The AWD module has calculated or measured that clutch B has passed its permitted temperature, usually after long slipping in deep snow, sand or mud, or when towing. In a twin-clutch rear module the two wheel clutches heat up separately, so one side can reach its limit while the other is still cool, for instance when only one rear wheel spins. GKN's actuator controller tracks clutch temperature, and suppliers patent staged protection: BorgWarner reduces engine torque from about 130 °C until the clutch drops below 110 °C, JTEKT estimates oil temperature from torque and wheel speed and then lowers the target torque. Audi documents the twin code C05DC00 for clutch A only. Once cooled, the system normally returns to full function. No manufacturer publishes a C05EB case.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / EB

Possible causes

  • Long wheel spin on one rear wheel in snow, sand or mud high
  • Towing or climbing with high, continuous torque transfer medium
  • Different tyre sizes or wear front to rear causing permanent slip medium
  • Aged or wrong fluid in the rear drive unit low

Symptoms

  • AWD overheating or temporarily disabled message
  • Less drive to the rear until the clutch has cooled
  • Engine power briefly reduced during wheel spin

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for C05EB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication