C05EA
4WD/AWD Clutch B Actuator Control Circuit High
The clutch B actuator line reads too high, usually from contact with a battery feed or because the low-side switch no longer pulls it down. With coil-type clutches the danger is current flowing although the module wants the clutch open: in JTEKT's ITCC the coil current sets the transmitted torque, so a partly energised coil lets the clutch drag. Mitsubishi Electric's patent checks for shorts via the terminal voltages in P or N and then turns both drivers off; TI treats a short to battery as its own diagnostic in the DRV8873-Q1 motor driver. A dragging clutch B can show up as tyre scrub or binding in tight, slow turns. No public manufacturer case exists for C05EA; C05E9 covers the short to ground and C05E7 the open circuit.
Possible causes
- Actuator wire shorted to a supply line high
- Low-side switch in the AWD module defective medium
- Corrosion bridging pins in the actuator connector low
Symptoms
- AWD warning, all-wheel drive disabled
- Possible binding or tyre scrub when manoeuvring
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05EA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.