C05E8
4WD/AWD Clutch B Actuator Control Circuit Performance
The clutch B actuator circuit is electrically intact, yet its response does not match the command: current, motor movement or the torque built up stays outside the expected band. Ford stores C05E8:71 in the AWD module of 2021–2022 Bronco Sport 2.0L vehicles (SSM 51117), together with C05D9:71 for clutch A; both lead back to the misaligned magnet ring of the rear drive unit motor, and the repair is a new motor instead of a complete unit. On twin-clutch modules such as GKN's Twinster each wheel clutch is set separately; GKN's actuator controller compensates for wear and runs its own self-diagnosis, so a clutch that lags behind its partner stands out. Once one side no longer follows, left-right torque control is lost and AWD is usually switched off for the trip.
Possible causes
- Misaligned magnet ring in the rear drive unit motor (Ford Bronco Sport 2.0L) high
- Worn or sluggish actuator motor or hydraulic control for clutch B medium
- Low battery voltage limiting actuator current medium
- Binding in the actuator mechanism or clutch pack low
Symptoms
- AWD fault message, all-wheel drive off for the rest of the trip
- Reduced traction off-road because one rear wheel is no longer controlled
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05E8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.