OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05E7

4WD/AWD Clutch B Actuator Control Circuit/Open

The AWD module finds no usable current path in its driver output for the clutch B actuator, most often an open coil, motor winding, connector or wire. A second clutch exists either in a twin-clutch rear drive unit with one clutch per rear wheel, or as a disconnect stage in the rear axle. Ford is the only maker with a public case: SSM 51117 lists C05E7:19 for 2021–2022 Bronco Sport 2.0L, the engine sold with the twin-clutch Badlands rear drive unit, while the single-clutch models in the same bulletin only log C0095. Ford traces it to a magnet ring that sits out of position inside the rear drive unit motor; the motor is now replaced on its own. Ford does not state which rear wheel belongs to B. Driver chips such as TI's DRV8873-Q1 test for an open load before switching on.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / E7

Possible causes

  • Open coil or motor winding in the clutch B actuator high
  • Misaligned magnet ring in the rear drive unit motor (Ford Bronco Sport 2.0L) medium
  • Broken wire or corroded connector between AWD module and rear drive unit medium
  • Faulty driver stage in the AWD module low

Symptoms

  • AWD warning lamp or message, rear axle no longer driven
  • Rear locking or torque vectoring function unavailable on twin-clutch units
  • Fault is present again immediately after clearing

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C05E7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication