OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05E6

4WD/AWD Clutch A Position Control Error

The closed-loop control that drives clutch A to a target position cannot hold or reach it: the deviation between commanded and measured position stays too large for too long. Magna describes an ECU that controls the angular position of the ball ramp actuator ring; Bosch drives its transfer-case clutch motor with a cascaded current and speed controller through an H-bridge; GKN's actuator controller handles fast clutch actuation and compensates for wear. A mechanical load, a weak motor, low voltage or a wrongly learned reference can each prevent the actuator from settling. Unlike C05E1, the sensor itself is plausible here. No manufacturer publishes C05E6; C05EF is the clutch B equivalent.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / E6

Possible causes

  • Actuator gear train or ball ramp binding high
  • Weak actuator motor or low supply voltage medium
  • Incorrectly learned reference position medium
  • Control software calibration issue low

Symptoms

  • AWD malfunction message, AWD disabled
  • Uneven or delayed torque transfer before the fault sets

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C05E6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication