OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05E5

4WD/AWD Clutch A Position Not Learned

The controller has no valid stored reference for clutch A, typically the touch or kiss point where the plates begin to carry torque. Bosch finds this point on a transfer-case clutch by running the motor at constant speed and intersecting two regression lines from the free-travel and loaded ranges; the run is repeated at engine start or at standstill because wear shifts the curve. Dana notes that each motor and control unit pairing gives its own kiss point. Magna moves the plates to a stand-by position just before contact. A new actuator, controller or clutch, an interrupted learn or lost memory leaves the value missing; a learn routine with a scan tool usually clears it. No manufacturer publishes C05E5.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / E5

Possible causes

  • Learn not run after replacing actuator, clutch or module high
  • Learn routine aborted, for example by low voltage or vehicle movement medium
  • Stored values lost after battery disconnection or module fault low

Symptoms

  • AWD warning directly after a repair
  • All-wheel drive disabled or harsh engagement

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C05E5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication