C05E4
4WD/AWD Clutch A Position Sensor Circuit Intermittent
The clutch A position signal drops out or jumps for short moments and then recovers, so the controller sees implausible steps between consecutive samples. The pattern points to a loose pin, a chafed wire that touches only on bumps, or moisture in the connector near the axle, rather than a dead sensor. Bosch's actuator design measures worm wheel position together with motor speed, and Dana reads motor shaft position continuously while the clutch is applied, which makes short glitches visible. AWD may drop out briefly and come back after the next start. No manufacturer publishes C05E4. Permanent faults use C05E2 or C05E3.
Possible causes
- Loose or corroded pin in the sensor connector high
- Harness chafing at the axle or subframe medium
- Sensor with internal intermittent fault low
Symptoms
- AWD warning that comes and goes
- Short losses of drive to the secondary axle
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05E4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.