C05E3
4WD/AWD Clutch A Position Sensor Circuit High
Here the clutch A position signal sits above the highest value a working sensor can deliver. Usual explanations are a signal line touching the supply or battery voltage, a lost sensor ground that lets the output float up, or an internal sensor fault. Bosch and Dana both describe actuator position sensing for motor-driven AWD clutches, on the worm wheel or on the motor shaft, so the controller can relate angle to clamping force. A value pinned at the top would suggest a fully closed clutch, which the controller cannot trust; it therefore releases the clutch and reports the fault. No manufacturer documents C05E3; the low-side variant is C05E2.
Possible causes
- Signal wire shorted to supply or battery voltage high
- Sensor ground open medium
- Sensor output failed high medium
Symptoms
- AWD warning lamp on
- All-wheel drive disabled until the fault is repaired
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05E3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.