C05E2
4WD/AWD Clutch A Position Sensor Circuit Low
The position signal from the clutch A actuator has dropped below its valid band. On a sensor powered by a reference supply this normally means the signal line is shorted to ground, the supply is missing, or the sensor output is dead. Position sensing on such actuators is described by Bosch (sensor on the worm wheel of a transfer-case clutch drive) and by Dana (Hall sensors or encoders on the motor shaft of a ball ramp actuator). Since a reading stuck at the bottom could be mistaken for an open clutch, the controller stops using it and disables the AWD clutch. No manufacturer publishes C05E2; C05E3 is the high-side counterpart.
Possible causes
- Signal wire shorted to ground high
- Sensor supply open or shorted medium
- Sensor output failed low medium
Symptoms
- AWD warning lamp on
- Vehicle drives with one axle only
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05E2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.