C05E0
4WD/AWD Clutch A Position Sensor Circuit
General electrical fault in the sensor that reports where the clutch A actuator stands, without the controller narrowing it down to low, high or intermittent. Electromechanical AWD clutches need this signal because the motor angle maps to plate travel and clamping force. Bosch describes a transfer-case clutch driven by a DC motor, worm gear and lifting disc, with its own position sensor on the worm wheel plus speed and current sensing; Dana reads the motor shaft position with Hall sensors or encoders. Without a valid position the controller cannot meter torque and opens the clutch. No manufacturer publishes C05E0; C05E1 to C05E4 are the more specific variants.
Possible causes
- Sensor wiring or connector damaged high
- Position sensor in the actuator faulty medium
- Sensor supply or ground from the AWD module missing low
Symptoms
- AWD warning, all-wheel drive switched off
- Traction loss when pulling away on low grip
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05E0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.