OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05DD

4WD/AWD Clutch A Performance/Stuck Disengaged

The AWD controller has commanded clutch A to close, but the speed difference across it or the actuator feedback shows that it is not transmitting the expected torque or has stayed open. Typical reasons are worn plates, a sticking actuator or a ball ramp that cannot travel far enough. Disconnect systems make the check routine: Audi quattro ultra opens a plate clutch behind the gearbox plus a separate disconnect clutch inside the rear differential and reconnects both within about 200 ms, and GKN's actuator controller monitors connection feedback and compensates for clutch wear. In a Magna coupling the ECU first indexes the ball ramp to a ready point with light plate contact. No manufacturer publishes a case for C05DD. C05DE is the reverse fault, a clutch that will not open.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / DD

Possible causes

  • Clutch plates worn, slipping under load high
  • Actuator or ball ramp sticking short of full travel medium
  • Wrong, aged or low clutch fluid medium
  • Damaged shift fork or dog teeth in the decoupling unit low

Symptoms

  • AWD malfunction message, vehicle behaves like two-wheel drive
  • Wheel spin and traction control interventions on slippery roads

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C05DD

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication