OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05DB

4WD/AWD Clutch A Actuator Control Circuit High

Set when the clutch A actuator line reads too high, typically because it touches battery voltage or because the low-side switch cannot pull it down. For an electromagnetic clutch, Mitsubishi Electric checks for this short with the selector in P or N by comparing the terminal voltages against normal values, then releases the clutch by turning off both drivers. A line stuck at supply can keep a coil partly energized, so on an ITCC-type coupling (current controls torque) the clutch may drag even when open is commanded. Newer BorgWarner couplings instead use a brushless motor with electronics integrated into the actuator unit. No public manufacturer case exists for C05DB; C05DA is the short to ground.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / DB

Possible causes

  • Actuator wire shorted to a supply line in the harness high
  • Output transistor in the AWD module stuck on medium
  • Corrosion bridging pins in the actuator connector low

Symptoms

  • AWD warning, all-wheel drive disabled
  • Possible binding or tyre scrub in tight turns if the clutch drags

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C05DB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication