C05DA
4WD/AWD Clutch A Actuator Control Circuit Low
The voltage measured on the clutch A actuator line stays below the expected level, which usually means a short to ground somewhere between the control module and the coil or motor. Mitsubishi Electric describes a method for an electromagnetic driveline clutch: a high-side PWM transistor and a low-side switch feed the coil, the terminal voltages are compared with their normal values, and on a ground fault both transistors switch off so the clutch opens. JTEKT's ITCC likewise sets its clutch force through coil current, and BorgWarner also offers electromagnetically actuated couplings. No manufacturer publishes a case for C05DA. C05DB covers the opposite fault, a short to supply; C05D8 an open circuit.
Possible causes
- Actuator wire chafed through and shorted to ground high
- Water or corrosion in the connector at the axle medium
- Coil or motor winding shorted to the housing medium
Symptoms
- AWD switched off with warning lamp
- Fault returns immediately after clearing
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05DA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.