C05D8
4WD/AWD Clutch A Actuator Control Circuit/Open
The AWD controller sees no plausible current path in the output that drives the actuator of clutch A, typically an open coil, motor winding or wire. Depending on the design, the actuator is an electromagnetic coil (JTEKT ITCC: coil current sets the transmitted torque) or an electric motor that turns a ball ramp through a worm gear, as in a Magna disconnect coupling. Ford names C05D8:19 for the Bronco Sport with the 2.0L engine, model years 2021–2022, in SSM 51117, together with C05D9:71 and the clutch B codes C05E7/C05E8; the cause there is a misaligned magnet ring in the rear drive unit motor, fixed by replacing the motor alone. With the circuit open the clutch cannot close, AWD is switched off and a warning appears.
Possible causes
- Actuator coil or motor winding open high
- Rear drive unit motor with misaligned magnet ring (Ford Bronco Sport 2.0L) medium
- Broken wire or loose connector at the rear axle medium
- Output stage in the AWD control module faulty low
Symptoms
- AWD warning lamp or message, vehicle drives on one axle only
- Wheel spin on slippery surfaces when pulling away
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05D8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.