OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05D5

Brake Master Cylinder Cut Off Valve

Electrical fault of the solenoid valve that separates the master cylinder from the wheel circuits in by-wire operation, so pressure comes from the motor and the pedal works against a simulator. In GM's booster-type EBCMs (XT4, 23OBDG07, 25OBDG03B) the valve driver reports over-current of about 4 to 6.5 A, an output stage above 195-220 °C, a lost power ground or lost freewheeling within 0.03 s. GM's integrated controller maps open and shorted driver tests of its simulator-side valve to C05D5 (Type A, MIL) but a coil above 265 °C as Type C without MIL; 25OBDG04A uses it for the traction control isolation valves. Bosch describes these isolation valves closing during by-wire braking. Expect reduced assist or a mechanical push-through fallback.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / D5

Possible causes

  • Valve coil shorted or open inside the hydraulic unit high
  • Valve driver stage or ASIC in the module defective medium
  • Poor power ground of the brake module medium
  • Valve overheated by excessive activation time low

Symptoms

  • Malfunction indicator lamp and brake warning
  • Loss of brake assist, pedal works on the master cylinder directly
  • ESC and traction control limited

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for C05D5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication