OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05D4

Brake Master Cylinder Piston Position Sensor Calibration Not Learned

No valid zero calibration exists for the master cylinder piston travel sensors. GM's integrated controller stores the end-of-line zeroing of its pedal travel sensors in non-volatile memory and reloads it each drive; C05D4 sets within 10 ms after start if the stored status shows the learn failed. GM lists sensor electrical faults, a moving vehicle or applied brake during calibration, and an offset too large, too small or unsteady, plus memory errors (19OBDG03D and 25OBDG04B, Type A with MIL). Hitachi learns stroke sensor zeros only with no brake request and discards a run that is interrupted. After replacing the brake unit, perform the calibration with a scan tool on a stationary vehicle. C05CC/C05CF cover offsets learned but out of limit.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / D4

Possible causes

  • Zeroing not done after replacement of the brake unit high
  • Calibration disturbed by vehicle movement or pedal input medium
  • Sensor offset too large, too small or unsteady medium
  • Memory error in the brake control module low

Symptoms

  • Malfunction indicator lamp and brake warning after start
  • Brake system in reduced mode until calibrated

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C05D4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication