C05CD
Brake Master Cylinder Piston Position Sensor B Circuit Voltage High
Channel B of the master cylinder piston travel sensor is stuck at a permanent high level. In GM's booster-type EBCMs the second channel is not sent over SENT like channel A but as a PWM signal around 1 kHz, which is why high and low here mean a line that no longer toggles: the module sets C05CD when it sees a steady high state for 0.2 s, read as a short of the PWM line to supply (19OBDG03D XT4 section, 23OBDG07, 25OBDG03B; Type A, one trip, MIL). Duty cycle or frequency outside 8.5-92 % or 900-1120 Hz falls under a separate communication code. Look for chafed wiring touching a supply wire or a sensor output stage that has failed high. C05CE is the stuck-low partner.
Possible causes
- PWM signal line shorted to supply voltage high
- Output stage of sensor channel B failed high medium
- Moisture or corrosion bridging pins in the connector low
Symptoms
- Malfunction indicator lamp and brake warning on GM models
- Booster runs on channel A only or reduces assist
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C05CD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.