C05CA
Brake Master Cylinder Piston Position Sensor A Circuit Voltage High
Channel A of the travel sensor at the master cylinder input rod reports a signal beyond its upper limit. In GM's booster-type brake modules this channel is a linear position sensor (LiPS) that talks to the EBCM digitally over SENT, so the high error is a message from the sensor itself: the Cadillac XT4 table in 19OBDG03D reacts within 0.033 s on the fast channel, 23OBDG07 and 25OBDG03B after 0.96 s on the slow channel, Type A with MIL. Line shorts and lost messages are filed under separate network codes there. Continental describes pedal modules that read travel with two sensors so one bad channel can be identified. Check the sensor connector and supply before replacing the booster assembly. C05CB is the low counterpart.
Possible causes
- Position sensor A reporting out-of-range high internally high
- Supply voltage of the sensor out of tolerance medium
- Sensor magnet or input rod out of position low
Symptoms
- Malfunction indicator lamp plus brake warning on GM models
- Reduced brake assist or changed pedal feel
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C05CA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.