C05C9
Brake Pressure Sensor Supply Circuit
Refers to the reference voltage the brake module provides to its hydraulic pressure sensors, not to one sensor's signal. If this feed collapses or rises, every sensor on it reads wrong at once, which is why the module checks the supply separately. Saab/GM monitors the 5 V reference of the brake pressure sensor and reacts within 0.1 s when that line touches ground or a voltage source. GM's integrated brake controller shows the usual window for such feeds: 4.85 to 5.15 V, held for 100 ms, on the pedal and motor sensor supplies (C05D1, C05BB). Tracking regulators like the TI TPS7B4253-Q1 are built for exactly this off-board sensor duty. No maker documents C05C9 itself. Unplug sensors one by one to find a shorted load.
Possible causes
- Reference line shorted to ground or to battery voltage high
- One pressure sensor internally shorted, pulling down the shared feed medium
- Sensor supply regulator inside the brake module defective low
Symptoms
- Several brake pressure codes at the same time
- ABS, ESC and brake assist warnings, functions off
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05C9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.