C05C8
Brake Pressure Sensor F Circuit/Open
General circuit fault of pressure sensor F, most often a break in one of its three wires (supply, signal, ground) or a connector that has lost contact. Where the reading ends up depends on the input circuit: Honeywell notes that after a power or ground loss the output goes high with a pull-up and low with a pull-down resistor, so an open line can look like C05C6 or C05C7 unless the module tells them apart. Saab/GM flags an open or high resistance on the brake pressure signal or 5 V reference after 0.1 s. Bosch advises checking the live value of a modulator-mounted pressure sensor before buying an expensive part. No manufacturer publishes C05C8 for sensor F. Repair wiring or connector, then clear and retest.
Possible causes
- Connector unplugged, corroded or with pushed-back pins high
- Broken wire in the sensor harness medium
- Internal open circuit in sensor F low
Symptoms
- ABS and ESC warning lamps on
- Stability control and brake assist functions not available
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05C8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- saabwisonline.com/9-5-9650/2011/5-brakes/tcs-esp/fault-diagnosis-diagnostic-trouble-codes/dtc-c0131
- prod-edam.honeywell.com/content/dam/honeywell-edam/sps/siot/ja/products/sensors/pressure-sensors/industrial-pressure-sensors/mip-series/documents/hon-ia-hss-mip-series-high-pressure-datasheet-en.pdf
- techtips.ie/Bosch/testing-for-a-brake-pressure-switch-fault.pdf