C05C6
Brake Pressure Sensor F Circuit Low
The signal of pressure sensor F sits below its valid band. Ratiometric 5 V pressure sensors normally output roughly 0.5 to 4.5 V; Denso describes treating 0 to 0.3 V as a fault zone, and with a pull-down resistor at the input a broken supply or signal wire also drags the reading toward zero. Saab/GM sets its brake pressure circuit code when signal or 5 V reference has a ground short or an open lasting 0.1 s and then disables ABS and traction control. No manufacturer publishes C05C6 for sensor F, so the letter-to-sensor mapping is not public. Measure supply, ground and signal at the connector before replacing the sensor. C05C7 is the high side, C05C8 the open circuit, C05C9 the shared supply.
Possible causes
- Signal wire shorted to ground high
- 5 V reference interrupted or shorted to ground medium
- Internal fault of pressure sensor F medium
Symptoms
- ABS, ESC and traction control warning lamps on
- Stability and traction control unavailable
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05C6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- patents.google.com/patent/US6657423B2/en
- saabwisonline.com/9-5-9650/2011/5-brakes/tcs-esp/fault-diagnosis-diagnostic-trouble-codes/dtc-c0131
- prod-edam.honeywell.com/content/dam/honeywell-edam/sps/siot/ja/products/sensors/pressure-sensors/industrial-pressure-sensors/mip-series/documents/hon-ia-hss-mip-series-high-pressure-datasheet-en.pdf