OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05C5

Brake Pressure Sensor F Circuit Range/Performance

Pressure sensor F delivers a voltage inside the electrical window, yet the value does not fit the braking situation: wrong offset at rest, a reading that disagrees with deceleration or the brake switch, or a pressure that does not match pedal travel. No manufacturer documents C05C5 for sensor F. GM shows the method on other channels: the XT4 brake module flags pressure sensor A when its offset exceeds 12 bar with the pedal released, and Saab/GM treats a pressure signal that conflicts with vehicle deceleration as not plausible. Bosch compares measured pressure against a stored curve over input rod stroke. Unlike C05C6 and C05C7, the wiring is usually intact; suspect the sensor, its calibration or the hydraulics.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / C5

Possible causes

  • Pressure sensor F drifting or with offset out of tolerance high
  • Calibration not matching after component replacement medium
  • Air in the system or hydraulic fault falsifying pressure medium
  • Increased contact resistance at the sensor connector low

Symptoms

  • ABS/ESC warning lamp, stability control off
  • Unusual pedal feel or uneven braking assistance

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C05C5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication