C05C4
Brake Pressure Sensor F Missing Calibration
The brake controller finds no stored calibration (offset or zero point) for pressure sensor F, the sixth hydraulic pressure sensor in its numbering. Which physical sensor carries the letter F is up to the maker, and none publishes C05C4. Comparable codes exist for sensors A and B: GM checks sensor B in its hybrid brake controller via test pulses after offset compensation, and Saab/GM calls for a scan-tool pressure sensor calibration after replacing the EBCM or the modulator. Hitachi learns pressure sensor zeros only while the master cylinder is pressureless and the pedal is released. A new module or hydraulic unit without the follow-up calibration is the usual cause. C05C5 to C05C8 cover the sensor's signal faults.
Possible causes
- Calibration skipped after module or hydraulic unit replacement high
- Calibration interrupted by brake application or low voltage medium
- Calibration data lost in the module memory low
Symptoms
- ABS, ESC or brake warning lamp on
- Stability control or brake assist functions disabled
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05C4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.