OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05C3

Brake Booster Motor A Supply Circuit

Points to the power feed of booster motor A: fuse, supply cable, ground or the module input that carries battery current to the motor stage, rather than the motor windings themselves. No manufacturer documents C05C3 publicly. Bosch specifies its iBooster for supply voltages above 9.8 V with up to 450 W of motor power, so a weak feed shows up quickly under load. Hitachi describes cutting the booster motor current when the supply drops below or rises above set limits, and motor gate drivers such as the TI DRV8343-Q1 lock out on supply undervoltage. Check voltage drop on feed and ground while braking. Phase current faults are C0590/C0591, internal driver faults C0595, and the position sensor supply has its own codes.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / C3

Possible causes

  • Blown fuse or corroded high-current feed to the booster high
  • Loose or corroded ground of the brake unit medium
  • Weak 12 V battery or charging fault causing voltage dips medium
  • Internal supply path of the brake module damaged low

Symptoms

  • Brake warning lamp, loss or reduction of brake assist
  • Hard brake pedal, especially at low battery voltage
  • Further faults for regeneration or driver assistance braking

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C05C3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication