C05C0
Brake Pedal Position Sensor A Not Learned
The control unit has no valid learned rest position for channel A of the brake pedal position sensor, so it cannot turn the raw signal into a reliable pedal travel. No manufacturer documents C05C0 publicly. The closest GM analogue is C0277 with failure type 4B: the body module reports that the home position of the pedal sensor was never learned and asks for a recalibration. Stellantis likewise requires a brake pedal learn in the ABS module after a PCM swap or update (C0042-54). Hitachi describes learning the stroke sensor zero only while no brake request is present. Typical triggers are a new sensor, a replaced module or an interrupted learn. C05C1 covers channel B, C0619 an offset outside the learn limit.
Possible causes
- Learn procedure not run after sensor or module replacement high
- Learn routine aborted because the pedal was touched or the vehicle moved medium
- Sensor channel A faulty or mounted out of position medium
- Learned values lost in the control module memory low
Symptoms
- Brake or ABS warning lamp and message in the cluster
- Brake lights or cruise control cancel react late or not at all
- Regenerative braking or brake assist functions restricted
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05C0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.