OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05BE

Brake Booster Motor B Position Sensor Supply Circuit High

C05BE is stored when the 5 V feed of motor B's position sensor exceeds its upper limit. No manufacturer documents it publicly. Two mechanisms are typical: the supply line has contacted a wire carrying battery voltage, or the reference ground of the sensor side has lifted, which makes every voltage measured against it look too high. Denso's patent illustrates the ground effect for a sensor read through a pull-down: a broken ground drives the signal above 4.7 V. In Hitachi Astemo's cross-check a rising ground pulls both references down while the monitor values stay put, which separates a ground fault from a true overvoltage. TI's tracker cuts its output path when shorted to battery. The booster then drops channel B and runs with motor A or reduced assist.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / BE

Possible causes

  • Motor B sensor supply shorted to a battery-voltage wire high
  • Open or high-resistance sensor ground raising the measured voltage medium
  • Second sensor supply regulator out of regulation low

Symptoms

  • Brake warning lamp and assist warning
  • Possibly further sensor codes if a shared ground is affected

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C05BE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication