C05BD
Brake Booster Motor B Position Sensor Supply Circuit Low
C05BD means the supply of motor B's position sensor reads below its permitted minimum – a ground short, a sensor pulling excess current or a weak regulator. No manufacturer publishes this code. Hitachi Astemo explains why two supplies need cross-checking: both share one ground, so without comparison the controller could not say which supply sagged. Each microcontroller there reads a 2.5 V reference from its own supply and a 3.75 V monitor of the other, and a low supply leaves a distinct pattern across those four values. A tracking regulator like the TPS7B4253-Q1 from TI holds its output current at a limit during a short, so the voltage drops instead of the part burning out. With channel B lost, the actuator relies on motor A or its first sensor and may lower assist gradually.
Possible causes
- Motor B sensor supply line shorted to ground high
- Damaged motor B position sensor drawing too much current medium
- Second sensor regulator in the control unit weak low
Symptoms
- Brake warning lamp on
- Assist fades gradually or is limited at high demand
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C05BD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.