C05BB
Brake Booster Motor A Position Sensor Supply Circuit Range/Performance
GM uses C05BB in the integrated brake control of 2019 models. There the processor generates two 5 V sensor supplies; each feeds one pedal travel channel plus one motor position channel. C05BB belongs to the second supply (PTS2 and MPS2), C05D1 to the first. GM sets it below 4.85 V or above 5.15 V for 100 ms, and also for an unsteady supply: every out-of-band sample adds 50 points and the fault matures at 800, so after 80 ms at the earliest; every good one subtracts 1, and the fault stays latched until ignition off. All three variants are Type A, MIL on the first trip. GM names a faulty motor position sensor, pedal travel sensor or circuit board as causes. GM thus books its MPS2 under a motor A code, though its MPS2 plausibility fault is C058E.
Possible causes
- Defective motor position sensor loading the shared supply high
- Defective pedal travel sensor on the same supply medium
- Fault on the brake control unit's circuit board medium
- Intermittent contact in the sensor supply wiring low
Symptoms
- Check engine lamp and brake warning on the first trip (GM)
- Service brake assist message, hard pedal
- Fault remains until the ignition is switched off
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C05BB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.