C05BA
Brake Booster Motor A Position Sensor Supply Circuit High
C05BA covers the opposite case: the 5 V feed of motor A's position sensor rises above its upper limit. The usual culprit is a supply line touching a battery-voltage wire, less often a regulator that has lost control. No manufacturer publishes C05BA; GM's 2019 brake module treats its sensor supplies as high above 5.15 V for 100 ms, filing them under C05D1 or C05BB. TI's TPS7B4253-Q1 tracker shows how such outputs are protected: it survives a short to battery and opens its internal switch within about 1 ms. Hitachi Astemo deliberately places its supply monitor voltage at 3.75 V, below 5 V, so overvoltage stays measurable. An overvoltage can also damage the sensor, so assist is withdrawn and the booster runs without motor support.
Possible causes
- Supply line shorted to a battery-voltage circuit in the harness high
- Sensor supply regulator in the control unit no longer regulating medium
- Poor control unit ground shifting the measured supply voltage low
Symptoms
- Brake warning lamp and assist warning message
- Hard brake pedal, longer stopping effort
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C05BA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.