OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05B8

Brake Booster Motor A Position Sensor Supply Circuit/Open

The rotor position sensor of booster motor A – Hall, magnetoresistive or a digital SENT angle sensor – is fed from a regulated 5 V output of the brake control unit. C05B8 reports that this feed is interrupted. No manufacturer documents the code publicly; GM's 2019 integrated brake control lists supply faults of its two motor position sensors under C05D1 and C05BB only. Denso's sensor patent shows why an open feed is hard to tell from a dead sensor: with a pull-down input the signal simply falls to 0 V. Hitachi Astemo's steering patent therefore monitors each sensor supply separately so the failed one can be identified. Without a rotor angle the booster cannot commutate its motor, so assist is cut back or lost and the brake warning appears.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / B8

Possible causes

  • Broken supply wire or pin between control unit and motor position sensor high
  • Sensor supply output in the brake control unit failed medium
  • Internal open in the position sensor's supply path low

Symptoms

  • Brake warning lamp and message such as service brake assist
  • Noticeably harder brake pedal
  • Regenerative or electronic brake functions unavailable

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C05B8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication