C05B7
Brake Booster Temperature Sensor C Circuit Intermittent/Erratic
C05B7 is meant for a temperature C signal that jumps or briefly drops out rather than failing permanently. No manufacturer documents it publicly. In Mitsubishi's Outlander PHEV the sensor C channel is judged against fixed limits with a detection time of up to one second, so short spikes there end up as C05B3 or C05B4 instead of a separate erratic code. Thermistor specialists attribute unstable readings mainly to mechanical stress: bent leads, board flex or shocks can produce intermittent contact before the part opens completely, and damaged coatings let moisture in. Because the sensor often sits on the booster's own board, a cracked solder joint is the usual suspect. The lamp may come and go with temperature or rough roads, and the fault tends to reappear after clearing.
Possible causes
- Cracked solder joint or lead at the thermistor high
- Loose pin or fretting corrosion at the booster connector medium
- Moisture reaching the sensing element through a damaged coating low
Symptoms
- Brake system warning lamp flickers or appears only at times
- Code returns after clearing, often after rough roads or temperature changes
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C05B7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.