C05B6
Brake Booster Temperature Sensor C Circuit Range/Performance
C05B6 targets a sensor C reading that is electrically inside its band yet does not behave like a real temperature: it stays flat during long assist phases, lags far behind the other channels, or contradicts the thermal estimate of the module. No manufacturer publishes this code. The risk is clear from Hitachi Astemo's booster patent, where measured motor and controller temperatures decide when motor current is cut back and when full assist returns; a believable but wrong value either throttles assist early or lets the drive overheat. Microchip notes that an NTC mounted in a power module tracks the case and heatsink, so a junction estimate has to be derived from it. Long-term drift through moisture or cracking is a known NTC weakness. A plausibility fault normally needs a drive with booster activity to set.
Possible causes
- Thermistor resistance drifted through ageing, moisture or micro-cracks high
- Sensor lost thermal contact with the part it should measure medium
- Thermal model or calibration in the booster control unit not matching the hardware low
Symptoms
- Brake system warning lamp on
- Assist reduced earlier than usual during long descents or repeated braking
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C05B6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.