C05B3
Brake Booster Temperature Sensor C Circuit Low
C05B3 means the third temperature channel of an electromechanical brake booster has dropped below its usable band. Mitsubishi documents the code for the Outlander PHEV: the DTC index pairs it with the brake unit's own code C18FC-18, EBA temperature sensor 1, and lights the brake system warning lamp plus the MIL after two trips. The value comes from the control electronics inside the electric intelligent brake unit. With the motor switch on, Mitsubishi stores the fault within one second if that reading is at or below −43 °C or at or above 169 °C. The fail-safe column says normal condition, so assist keeps working. Mitsubishi files its second sensor under C0579/C057A. Listed causes are harness, connector and the brake unit itself.
Possible causes
- Fault in the temperature detection inside the electric brake unit's control module high
- Corroded or loose brake unit connector or damaged harness medium
- Supply disturbance during start-up distorting the reading low
Symptoms
- Brake system warning lamp on
- Check engine lamp on after two trips (Mitsubishi)
- Braking assist usually unchanged
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C05B3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.