OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05AF

Brake Booster Motor B Current Sensor Circuit Range/Performance

C05AF is the plausibility check of the current measurement on booster side B, the second motor or winding system. No manufacturer publishes it. A separate sensing chain for B is needed wherever each power module controls its own winding, as in the Hyundai Mobis dual-winding booster motor, since every module must know its phase currents to regulate torque and to judge its own health. Typical checks run at start-up, before current flows: the controller shorts the amplifier inputs (TI's DRV8343-Q1 offers a pin for this), records the zero point and rejects values outside a band. GM's counterpart for side A, C0596, additionally injects test offsets. A failed B measurement normally leads to side B being switched off and assist relying on side A, possibly with lower power.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / AF

Possible causes

  • Faulty current sense amplifier of side B medium
  • Zero offset of side B outside its allowed band medium
  • Damaged shunt or solder joint in power module B low

Symptoms

  • Brake assist or brake system warning
  • Possibly weaker assist under hard braking

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for C05AF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication