OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05AB

Brake Blending Separation Valve Performance

C05AB concerns the separation valve that decouples the driver's master cylinder from the wheel circuits while the brakes work by wire, so that pedal pressure does not cut into regenerative braking. It is usually open without current, so the pedal acts on the wheels if power fails, as in Continental's brake-by-wire layout. A performance fault means it does not seal or switch as expected. Mando's patent shows how a leak is found: if pedal simulator pressure follows circuit pressure too closely, fluid is getting through; the valve is re-energised to free a stuck seat, and after repeated failures the system warns and returns to direct pedal braking, as leaking pressure can kick back into the pedal. Toyota patents isolate a valve by response delays. No manufacturer publishes C05AB.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / AB

Possible causes

  • Dirt or debris on the valve seat causing leakage high
  • Valve coil or its driver in the module not switching properly medium
  • Old or wrong brake fluid making the valve sluggish medium
  • Pressure sensor errors making the valve look faulty low

Symptoms

  • Pedal kickback or vibration during braking
  • Regenerative braking reduced, brake warning message
  • Brakes switch to direct pedal operation with higher effort

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for C05AB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication