C05A3
Wheel Speed Sensors Supply Circuit High
Active wheel speed sensors are fed by the ABS module and send their pulses back as a current on the same pair of wires, as HELLA explains. C05A3 reports that this common supply is too high or cannot be switched off. GM's 2016 and 2019 hybrid brake controllers look for reverse current on the supply line, the sign of a short to the battery feed, for over 3.5 s. A 2019 GM EBCM with a system ASIC uses C05A3 for two cases: the sensor supply exceeds its overvoltage limit, after which the ASIC turns off all four high-side switches, and a periodic test in which a supposedly switched-off high side is still live. Both are Type A with MIL. Allegro rates its wheel speed sensor IC for 24 V and clamps at 28 V. With no wheel speeds, ABS, ESC and traction control stop working.
Possible causes
- Wheel speed sensor wire chafed and shorted to battery voltage high
- Supply switch or ASIC in the brake module stuck on medium
- Water in a wheel speed sensor connector bridging to a powered circuit low
Symptoms
- ABS, traction and stability control warning lamps on at the same time
- Several or all wheel speed signals lost, speedometer may drop out
- MIL on (GM)
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C05A3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2016/16OBDG02 Hybrid Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2019/19OBDG03D Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2025/25OBDG04A.pdf
- hella.com/techworld/au/technical/sensors-and-actuators/check-and-change-abs-and-wheel-speed-sensors/
- allegromicro.com/-/media/files/datasheets/a19302-datasheet.ashx