C05A2
Brake Pressure Sensor E Range/Performance
Here sensor E delivers a voltage that is electrically valid but does not fit the braking situation: a drifting zero point, wrong gain or a value that disagrees with other pressure signals. No maker documents C05A2 publicly. The usual tests are known from related sensors. GM's hybrid brake controller learns each wheel sensor's zero while the pedal is released and flags an offset beyond ±1,500 kPa at once. A Bosch patent sets an offset fault when the compensation passes a limit, lights the ABS and ESC lamps and clears it only after a good check while driving. A Lucas/ZF patent opens the valves at standstill so all sensors see one pressure; with at least three of them the drifting one and its error can be identified. Trapped pressure, sensor drift or a ground offset are typical causes.
Possible causes
- Sensor zero point or gain drifted with age or temperature high
- Residual pressure trapped in the circuit during the zero learn medium
- Ground offset between sensor and module distorting the reading low
Symptoms
- ABS and ESC warning lamps on
- Stability or regenerative brake functions reduced
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C05A2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.