OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05A1

Brake Pressure Sensor E Circuit/Open

This code points to an interrupted circuit of sensor E: a broken signal, 5 V supply or ground wire, or a connector that has lost contact. No maker documents C05A1 publicly. Whether an open is recognised as such or as low or high depends on the input circuit, which is why many systems book it under C059F or C05A0 instead. Honeywell specifies that with an external pull-up resistor a power or ground loss drives the output high, with a pull-down low. A Denso patent adds a check for creeping contact resistance, which produces in-between voltages that such resistor schemes miss: the supply is briefly raised so the sensor outputs a fixed test voltage. Bosch's EBS monitors each of its pressure sensors separately. Check connector and wiring before condemning the sensor.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / A1

Possible causes

  • Corroded or loose connector at the sensor or hydraulic unit high
  • Broken signal, supply or ground wire medium
  • Internal open circuit in the sensor low

Symptoms

  • ABS/ESC warning lamp on, possibly coming and going
  • Stability control and brake assist switched off

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C05A1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication