OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C05A0

Brake Pressure Sensor E Circuit High

C05A0 is set when sensor E reports a voltage above its usable range. In the Denso patent on vehicle pressure sensors the band from 4.7 to 5 V is reserved for faults, and a lost ground wire pushes the output into it through the divider formed by the sensor's internal resistance and the module's pull-down resistor. Honeywell's ratiometric transducers deliberately drive their output to 97.5 % of supply on an internal fault or overpressure, so a high code can also come from the sensor itself. A short to the 5 V reference or to battery voltage is the other common case. No maker publishes C05A0; GM's 2019 EBCM uses more than 95.24 % of supply for 100 ms on comparable sensors, Type A. The module would otherwise see braking that is not happening, so it ignores the sensor and limits ESC.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / A0

Possible causes

  • Signal shorted to the 5 V reference or to battery voltage medium
  • Open sensor ground lifting the output to the upper rail medium
  • Sensor signalling an internal fault at full scale medium

Symptoms

  • ABS/ESC warning lamp on
  • Stability control unavailable, brake lights may be requested falsely on some systems

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C05A0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication