OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C059F

Brake Pressure Sensor E Circuit Low

The signal of brake pressure sensor E sits below its valid window. Analogue brake pressure sensors run on 5 V and report roughly 0.5–4.5 V; a Bosch trainer notes such a sensor shows under 1 V with the brake released. A Denso patent on vehicle pressure sensors reserves 0–0.3 V as an error band and explains that, with a pull-down resistor at the module, a broken supply or signal wire also drags the reading to 0 V, so an open circuit can appear as low here. Other causes are a short of the signal to ground or a failed sensor. No maker documents C059F publicly. GM's hybrid brake controller uses the same kind of check on its wheel pressure sensors: below 0.3 V lasting 100 ms, rated Type A. Sensor E is usually built into the hydraulic unit, so a sensor fault often means replacing that unit.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 9F

Possible causes

  • Signal wire of the sensor shorted to ground medium
  • Open 5 V supply or signal wire pulled low by the module input medium
  • Pressure sensor failed internally (often part of the hydraulic unit) medium

Symptoms

  • ABS/ESC warning lamp on
  • Stability control and pressure-based brake functions switched off

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C059F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication