C059E
Brake Pressure Sensor E Missing Calibration
C059E reports that sensor E, one more pressure sensor in a multi-sensor brake unit, has never been calibrated successfully or that its record is lost. No maker documents C059E publicly; for sensor E only the circuit codes C059F–C05A2 exist. GM's published logic for related sensors shows what can go wrong: for its pedal travel sensor (C05D4) the stored status reports a failed zeroing if the sensor had an electrical fault, the car moved or the brake was applied during calibration, or the offset was too big, too small or unsteady. For pressure sensor A GM's 2025 tables check only the status flag, 500 ms after wake-up, Type A. Saab lists module or modulator replacement as reasons to recalibrate. Rerun the calibration with the car stationary and the pedal untouched.
Possible causes
- Calibration run while the vehicle moved or the brake pedal was pressed high
- Calibration skipped after replacing the brake module or hydraulic unit high
- Sensor offset too large or unstable so the calibration is rejected medium
Symptoms
- ABS/ESC or brake system warning lamp on
- Brake assist or stability functions disabled
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C059E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.