C059C
Brake Pressure Sensor C Missing Calibration
For pressure sensor C the module finds no confirmed calibration record. Such a record usually holds the zero offset and a status flag written on the assembly line or by the scan tool. No maker documents C059C publicly. Related checks are published: GM's 2019 EBCM reads only that status flag for its master cylinder sensor (C0560) 500 ms after wake-up, Type A with MIL, and Ford hybrids compare checksum and sensor ID between sensor and module (150 or 70 ms). GM's 2016 hybrid controller uses C0571–C0574 for a master cylinder sensor but files its calibration fault under C0560, so letters in calibration codes need not match circuit codes. Saab names module and modulator replacement as reasons to recalibrate with the brake released and the car secured.
Possible causes
- Sensor calibration not performed after replacing the brake module or modulator high
- Calibration aborted because the pedal was pressed or the vehicle moved medium
- Stored data does not match the fitted sensor (checksum or ID) low
Symptoms
- ABS/ESC warning lamp on
- Stability control or brake assist functions switched off
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C059C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2019/19OBDG03D Diagnostics.pdf
- fordservicecontent.com/Ford_Content/catalog/motorcraft/OBDSM1901_HEV.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2016/16OBDG02 Hybrid Diagnostics.pdf
- saabwisonline.com/9-5-9650/2011/5-brakes/tcs-esp/adjustment-replacement/brake-pressure-modulator-valve-pressure-sensor-calibration