OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0599

Brake Booster Control Module Missing Calibration

C0599 means the control unit of an electric brake booster finds no valid calibration data. Stand-alone electromechanical boosters such as Bosch's iBooster carry their own controller, which converts the reading of a built-in differential travel sensor into motor commands; how the pedal feels is set by software parameters. A Bosch patent describes keeping the characteristic between booster travel and driver input in exactly this unit. If that data set or its learned values are absent, typically after a booster or module swap or an aborted flash, the code is stored. No maker documents C0599 publicly. As a yardstick, GM's check for a pressure sensor calibration (C0560) only reads the stored end-of-line status 500 ms after wake-up. Expect weak or missing assist and a hard pedal until the setup routine has run.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 99

Possible causes

  • Booster or its control module replaced without running the setup/calibration routine high
  • Software update or programming of the booster module aborted or incomplete medium
  • Internal memory fault in the booster control module losing stored data low

Symptoms

  • Brake warning or service brake assist message in the cluster
  • Hard brake pedal with reduced power assist
  • Driver assistance functions using the booster (e.g. emergency braking) unavailable

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for C0599

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication